Fatal error(35)

Environmental Forum Forums EddyPro Fatal error(35)

Tagged: 

This topic contains 7 replies, has 5 voices, and was last updated by  IsraelB 4 years, 4 months ago.

Viewing 8 posts - 1 through 8 (of 8 total)
  • Author
    Posts
  • #1445

    Marta Sá
    Participant

    Dears,

    I’m trying to process my data with EddyPro 4.1, marking the flux

    averaging interval of 1 minute, but do not know for what reason I can

    not.

    My raw files are in 30-minute intervals.

    Could you help me in this matter?

    “Fatal error(35): Sorry, something went wrong. EddyPro was not able to process any raw file.

    Run will be closed without creating result files.”

    #1799

    IsraelB
    Keymaster

    Hi Marta,

    Am I reading correctly that you are trying to process 1 minute fluxes? That seems a bit unusual. Can you post a sample data, and the metadata and project files you are using?

    #1801

    Marta Sá
    Participant

    Hi IsraelB,

    I really need this interval, because I need to compare the result of

    the wind direction with the output of our sonic 2D, which are sampled

    for 1 minute.

    I need to check an error in data wind direction and this information

    will be confirmation of our problem.

    Thank you again!

    #1898

    ThomasG
    Participant

    Hi Marta and Israel,

    I get the same error code using half-hourly slt files calculating half-hourly fluxes (averaging interval also half hourly). The message in the Output Console is:

    Fatal error(35): Sorry, something went wrong. EddyPro was not able to process any raw file.

    Run will be closed without creating result files.

    Why result files are not created? I attach my edipro, metatdata and a raw data file.

    Thanks for any help – Thomas

    #1899

    gerardo
    Participant

    Hello Thomas,

    it seems that your files were not not uploaded. Would you please try again, and if that doesn’t work, please send the files to me at gerardo.fratini@licor.com.

    Cheers,

    Gerardo

    #1900

    ThomasG
    Participant

    Sorry, here they are.

    #2014

    MonoSurround
    Participant

    Hy,

    i’ve the same problem!

    I try to process 20Hz data. Daily ASCII-Files are used for input. EddyPro (5.1.1) starts to process data (30min averaging) and breaks every time at the last averaging period. It happans reagardless of the duration of the whole analysis period.

    What I am doing wrong?

    Thanks for answers..

    Alex

    #2016

    IsraelB
    Keymaster

    Hi Alex,

    Are temporary output files created? And do they contain the results up until that last half hour?

Viewing 8 posts - 1 through 8 (of 8 total)

You must be logged in to reply to this topic.

Comments are closed.